KeeGuard not only meets but exceeds current safety requirements for maximum roof edge protection.

• KeeGuard Assemblies use fittings that are TÜV tested and approved
• Integral toeboard fixings for full health and safety compliance
• Assemblies are fitted with anti-slip rubber pads for safety and to protect the roof membrane
• Works on a tested and proven counterbalance system

KeeGuard components are galvanized providing long lasting roof fall protection you can depend on.

• All pipe is galvanized to ASTM A53
• All fittings are galvanized to meet the requirements of EN ISO 1461:199
• Featuring case hardened steel set screws with Kee Koat™ protection
• Uses reliable Kee Klamp® fittings which provide strong, rigid, virtually maintenance free connections

KeeGuard employs a pre-fabricated modular design that allows you to reconfigure your system on site with ease if needed.

• Sections can be added to, or taken down and re-erected on site
• A variety of uses including skylight protection, walkway demarcation, stairwell protection and more…
• Compatible with almost all variations of flat roofs (up to 3 degrees), be they circular, square, rectangular or multilevel
• Available from our warehouse or through authorized installers

KeeGuard has a unique modular design that takes the complexity and cost out of roof edge fall protection – for good.

• Unique open style fitting allows quick installation of horizontal rails
• Minimum components for ease of fitting and installation
• Uprights allow angle adjustment of up to 11 degrees
• No drilling, special anchoring or penetration of the roof membrane
• No welding, bending or threading required on site, and no specialty tools are needed

KeeGuard has been independently tested and meets or exceeds the following North America and International Requirements:

• OSHA Standard 29 CFR 1910.23
• OSHA Standard 29 CFR 1926.501, 29 CFR 1926.502
• Canadian National Building Code 4.1.10.1(1)(e), 4.1.10.1(2), 4.1.10.1(4)
• Ontario Building Code Section 4.1.10.1(1)(b), 4.1.10.1(2), 4.1.10.1(4)
• HSG-33 Health & Safety in Roof Work
• HSE Specialist Report No 15: 1988
• HSE Sheet 21 “Working on Flat Roofs Protection Against Falls”
• BS 6399: Part 2 1995 Wind Code
• EU Directives & CDM Regulations
• BGV A1: 2000, BGG 928 & BGR 184
• Health, Safety & Welfare Regulation 13 “Falls or Falling Objects” 1992
• NFE 85-003
• EN ISO 14122: PT3

The innovative counterbalances are engineered to be environmentally friendly. Each counterbalance is made from 100% recycled PVC to replace the previous counterbalance, which was composed of galvanized steel.

• Carrying handles molded into design
• Available in grey, orange, and custom color
• Reflective labels on each weight
• Surface promotes traction and grip
• Made from 100% recycled PVC