Helping to Keep Your Workers Safe with Fall Protection Systems and Equipment

The city of Cincinatti resides in the state of Ohio and Ohio abides by the Federal OSHA CFR 2019 rules when it comes to fall protection.

As well as adhering to the OSHA guidelines, the city of Cincinatti follows the Ohio Building Code (OHBC). OHBC adheres to the International Building Code standards, but applies amendments that are relevant to the state.

Understanding Cincinatti Fall Protection Requirements

OSHA Standard Interpretation - Do I follow OSHA or local building code in Cincinnati?

The strictest rules must be followed. Where local codes are in effect, they are generally more specific and more stringent than applicable OSHA regulations. Compatibility with OSHA regulations is seldom an issue. (source)

OSHA 1910.5(c)(1) - What OSHA code applies in Cincinnati?

If a particular standard is specifically applicable to a condition, practice, means, method, operation, or process, it shall prevail over any different general standard which might otherwise be applicable to the same scenario. (source)

OHBC 1015.2 - Where is guardrail required in Cincinnati?

Guards shall be located along open-sided walking surfaces, including mezzanines, equipment platforms, aisles, stairs, ramps, and landings that are located more that 30 inches measured vertically to the floor or grade below at any point within 36 inches horizontally to the edge of the open side. (source)

OHBC 1015.2 - At what height do I need fall protection or guardrail in Cincinatti?

Guardrails are required on any elevated walking surface above 30 inches. (source)

OSHA 1910.29 - What can a guardrail be made out of in Cincinnati?

Guardrails, as long as they comply with all applicable standards, may be made out of any material. (source)

OHBC 1015.3 - How tall does rooftop guardrail need to be in Cincinatti?

Guards can not be less than 42 inches high. (source)

OSHA 1926 Subpart M App B - How far apart can guardrail posts be in Cincinnati?

Guardrail posts may not be spaced more than eight feet apart. (source)

OSHA 1926.502(b)(2) - Do I need a mid-rail in Cincinatti?

Midrails must be installed between the top edge of the guardrail system and the walking/working surface when there is no wall or parapet wall at least 21 inches high. (source)

OSHA 1910.29(k) - When do I need a toeboard in Cincinnati?

Toeboards are required when there is danger of items falling from an elevated walking-working surface onto workers below. (source)

OHBC 1607.8.1.1 - What are the load requirements for rooftop railing in Cincinatti?

Handrails and guards must be designed to resist a concentrated load of 200 pounds. (source)

OSHA 1910.29(b) - Can I use a non-penetrating guardrail in Cincinnati?

Yes, as long as it complies with all other guardrail standards. (source)

OHBC 1014 - Can guardrail serve as handrail in Cincinnati?

Guardrails and handrails serve two different purposes and have different requirements. A handrail may be attached to a guardrail, but they are not one in the same. (source)

OHBC 1015.2 - If my rooftop is lower than 22 feet but I have mechanical equipment close to the edge, do I need rooftop railing in Cincinatti?

Guards must be located along open-sided walking surfaces, including equipment platforms, that are located more that 30 inches measured vertically to the floor or grade below any point within 36 inches horizontally to the edge of the open side. (source)

OHBC 1015.7 - If my rooftop is lower than 22 feet but I have a roof hatch close to the edge, do I need rooftop railing in Cincinatti?

If you have a roof hatch located within 10 feet of the roof edge, the roof access or roof edge must be protected by guardrail. (source)

OSHA 1926.501(b)(4)(i) - When is protection required when falling through a hole in Cincinatti?

Employees must be protected from falling through holes, including skylights, that have more than a 6 foot drop, by personal fall arrest systems, guardrails, or covers. (source)

Popular Fall Protection Products in Cincinnati

Have any Questions about Fall Protection?

We pride ourselves on not being "just another company trying to sell you something". We take safety seriously and we want to partner with you to make sure you receive the right fall protection solution that meets compliance requirements, protects your workers while they work at height, and reduces liability for your company.

Michael Hannah at desk
Michael Hannah
Fall Protection Specialist
Or call a specialist at:
1.866.527.2275

Contact Information

Michael Hannah
Fall Protection Specialist

Shopping Cart

Show Pricing

Option available in footer.